You should also print out the pcb footprint at 1:1 scale and check that the holes align with a real part (it is less important in the SMD version and I am assuming the OP got the positioning correct …)Įdit2: I replaced the part with one with the holes set to 0.031in which shows as the recommended value for a 2mm male header. 1in headers) which are likely too large for the 2mm headers this looks to use. Note that the holes are set to 0.038in (suitable for. Through hole parts will change from top to bottom on single sided.Īlthough I see when I look at breadboard that it is actually a dual part (SMD and through hole) and thus should have a through hole version which will do what you want. If it was on the top it would not connect to anything. Yes, because there is only one copper layer on a single sided pcb, so it will only go on the bottom (as it is SMD) in order to connect to the copper.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |